POR-15 Weld-Thru Primer can be applied over cured POR-15 Rust Preventive Coating and all POR-15 topcoats to enable quick refinishing and recoating of these products. POR-15 Weld-Thru Primer also adheres well to steel, aluminum, stainless steel, brass, and other primed and painted surfaces.
- Excellent for use over cured POR-15 Rust Preventive Coating
- Reduces Welding Distortion and Splatter
- Minimises heat zone during welding
- Provides corrosion resistance to welding surfaces
- Leaves surface strong and protected
- Water resistant after 15 minutes
- Topcoat in 30 minutes
For maximum adhesion sand surfaces to be painted with 320 grit sandpaper. All surfaces must be clean and free of all dirt, loose rust, oil, grease, wax, soap, loose paint and any other matter. Clean painted and bare metal surfaces with POR-15 Cleaner Degreaser. Metal surfaces should be treated with POR-15 Metal Prep for maximum adhesion.
Shake can well before spraying. Spray two light coats of POR-15 Weld-Thru Primer and allow 10 to 15 minutes between coats. POR-15 Weld-Thru Primer can be topcoated in 30 minutes. It is not necessary to sand POR-15 Weld-Thru Primer before topcoating. Dry time: It cures to touch in 30-60 minutes. Second coat can be applied in 10-15 minutes, depending on ambient temperature and humidity.
Cleanup: To prevent clogs in spray nozzle, hold can upside down and spray until clear gas appears. Empty aerosol cans are recyclable or may be discarded in regular trash pick-up. Do not incinerate or compact.