Plastic Adhesion Promoter Clear

How To Use

• Usage
  Bare plastics and vinyl
• Prep
  Prepare surface by removing loose paint, dirt, rust, grease, wax etc. For best results use a grease and wax remover to clean the surface.
• Application
  To spray, hold can parallel and 8–10 inches from surface and use in an even, sweeping motion. To avoid runs and sags, apply 2–3 light coats, allowing 3 minutes between each coat. Apply topcoat within 10 minutes of last adhesion promoter coat. Covers approximately 12–14 square feet. After each use, invert can and spray until clear gas comes out. If spray button becomes clogged, wear eye protection and wipe off orifice with lacquer thinner