Duplicolor Multi-Purpose Self-Etching Primer

How To Use

• Usage
  Bare metals and aluminum
• Prep
  Prepare surface by removing loose paint, dirt, rust, grease, wax etc. For best results use a grease and wax remover to clean the surface. Scuff/sand surface with 320-grit sandpaper. Wipe surface down again with grease and wax remover. Then let dry.
• Application
  To spray, hold can parallel and 8-10 inches from surface and use in an even, sweeping motion. Apply 2 to 3 thin coats, allowing etching filler to dry 2 minutes between coats. Repeat until area is built up. After final coat, allow self-etching primer to dry 30 minutes before sanding with 400-grit sandpaper or applying the topcoat. Can be handled in 1 hour. Covers approximately 12–14 square feet. After each use, invert can and spray until clear gas comes out.
• Application Conditions
  Use at temperatures between 60 °F (16°C) and 95°F (35°C) and when humidity is low