Medium 120 Grit Lapping Paste (2.5kg)

Best Uses & Recommended Practices

Here are tips to get optimal results with Chemico Medium 120 Grit:

1. Prepare the surfaces: clean off oil, dirt, rust; ensure surfaces are flat/level (especially for blades, mating faces etc.).

2. Correct blade/edge alignment: e.g. for mower blades, align both within approx. 1mm height difference before using paste. Helps ensure even sharpening.

3. Apply the paste: use a brush or swab to spread an even layer. Don’t over‑apply — excess leads to waste and mess.

4. Running / lapping: run the machine in reverse lapping (if available) or use blades at slow speed; allow 1 minute or so; check finish; reapply if necessary.

5. Water/rinse: Because it’s water‑based, rinse the paste off after use; clean parts thoroughly. Dry them to avoid rust.

6. Use progressively: If starting from worse condition, begin with coarser gel (80 grit or coarser), then move to 120, and if necessary finer (e.g. 220) for final smoothing.

7. Storage: after use, wipe off excess paste from the tub edge, close tightly, store in proper temperature range (0‑35°C), protect from frost

High performance Water Based Lapping Paste Available in: 80 (Coarse), 120 (Medium), 220 (Fine) .

2.5kg tamper evident tubs.

Also available 80 (Coarse) and 120 (Medium) Grit in 5kg.

A range of high performance, water based Lapping Pastes, incorporating a unique gel system that enhances the sharpening characteristics of silicon carbide grit. Depending on the degree of wear and type of equipment the correct grade is available from fine to coarse. An extremely stable easy to use paste having low environmental impact which does not require cleaning after use. Developed for the maintenance departments of golf clubs, municipal organisations, schools and sporting venues.

* Oil Free

* Low odour

* Easily to use

* Improves Cutting Performance

* Cohesive gel provides faster sharpening

* Suitable for most types of equipment

* Low fling formula, which penetrates to the sharpening surfaces

* Non drying, rewettable formula, rinses with water even after standing

* Resists slumping

* Prevents corrosion on newly sharpened blades

Application and Storage Adjust cutting edges to be level and within 1mm of each other and coat blades with compound using swab or brush. This can be done whilst the blade are running in reverse lapping gear but obvious safety precautions should be taken. The selection of coarse, medium or fine will depend upon type of equipment and degree of sharpening needed. Run machine without cutting grass for up to 1 minute and re-apply if necessary. Readjust blades accordingly. Store between 0-35 degrees C. Store in tightly closed containers. Protect from frost.