One side is magnetised for use on steel while the other side has adhesive for use on non-magnetic surfaces such as aluminum. Disposable guide measures 1/2″ wide and comes in a 20′ roll. A must have for plasma cutting patch panels or for use on contoured panels were straight edge won’t work.
20 ft long, 1/2 inch wide and 1/16 inch thick.
Always wear appropriate safety equipment when plasma cutting.
Use the disposable plasma cutting guide to assure accurate work in straight line cutting or gentle curves. Adheres with either the adhesive tape side (remove white paper to expose adhesive tape) or by magnetism on bare, clean steel.
Note: On steel pieces over 1/8” thick use the adhesive side to assure guide stays in place as the slower cutting speeds and greater heat tends to reduce magnetism in guide.